Baxi 829 Manual do Utilizador

5120178/02INSTALLER AND OWNER GUIDEImportant: Please keep your guide in a safe place for future reference© Baxi Heating U.K. Limited 2006.Model 829Ele

9. At the back of the heater there will be a longpiece and a short piece of wire coming through thetwo holes. Hold the short piece and give the longpi

Preparing the heater for installation.Twilight model - The spacer frame will need to befitted to the heater at this point using the nine blackscrews p

Fitting the heater.1. Decide the location of the heater. 2. If the heater is to be fixed in an elevated position (i.e.above hearth or finished floor h

Fitting the fascia.Twilight fascia only.1. There is a fuel bed support supplied withthe Twilight heater. Slip this between theglass and metal panel on

Chic fascia only.1. Supplied in the fasciapack are two tubular trimsets. The lower trim set hasa flat plate fitted to the rear.Hang the upper and lowe

Envy fascia only.1. Supplied in the fascia pack is a canopy trim. Hangthis at the top of the fascia (See figure 17).2. Hang the lower trim at the bott

USING THE HEATERImportant SafetyNever cover the heater or obstruct the openings at the base of the heater, this couldcause overheating and consequent

due to the indeterminate life span andease of replacement, they are specificallyexcluded from the guarantee.To replace the light bulb(s).1. To gain ac

4. I Have a problem that is different to those in the previous examples 1- 3.Following is a list of useful telephone numbers.For general advice about

the nation’s favourite forPLUMBING & HEATING SUPPLIESSECURE PAYMENTSshop online with confidenceFREE SHIPPINGon all orders over £100 to mainland UK

© Baxi Heating U.K. Limited 2006.All rights reserved. No part of this publication may be reproduced in any material form(including photocopying), stor

Safety First.Baxi Fires Division heaters are CE Approved and designed to meet the appropriateBritish Standards and Safety Marks.Quality and Excellence

! One person should be sufficient to lift the heater. If for any reason this weight is considered too heavy then obtain assistance.! When lifting alwa

FITTING THE HEATERThe installation of this heater requires a reasonable level of DIY skills.Please read this guide thoroughly before commencing instal

Important Electrical SafetyThe heater must notbe located in front of or under an electrical socket, the socket mustalways be accessible in order to di

Heater Fixing.All of the fixings and loose parts supplied with the heater have been identified as infigure 3.Additional fixings may be required if fit

If fitting the heater onto a decorative hearth surface such as marble or tile it is advisableto protect the hearth surface. Do not drag the heater acr