Baxi 828 Manual do Utilizador

5117528/04INSTALLER AND OWNER GUIDE© Baxi Heating U.K. Limited 2006.Model 828Electric HeaterFitted with one of the following fasciaAdage, Anthem, Bole

Heater fixing.All fixings supplied with the heater have been identified in figure 5.The heater must be fixed into position to prevent it from being ti

Method A - Screw fixing.Note - If fixing to marble it is recommended thatMethod B - ‘Wire fixing’ is used. Drilling marblewithout the correct tools an

9. At the back of the heater there will be along piece and a short piece of wirecoming through the two holes. Hold theshort piece and give the long pi

5. Insert two wall plugs provided into the holes.6.Insert a ‘C’ screw into each hole and screw in until there is approximately 6mm ofscrew protruding

Fitting the light diffuser.1.There is a light diffuser supplied with the heater (See figure 5). Place this on to themetal flange below the plastic scr

support (a glove is provided with the coalpack). It is not necessary to use all the coal orpebbles supplied.Fitting the Bolero and Dream fascia.1. Fit

fascia.4. Place the loose pebbles / coals on top of the fuel support. It is not necessary to use allthe pebbles / coals supplied.Fitting the Capri, Fl

Fitting the Coast and Style fascia. 1. The heater is supplied with two firefront hanging brackets. Locate these at the side ofthe heater as in figure

USING THE HEATERImportant SafetyNever cover the heater or obstruct the openings at the base of the heater, this couldcause overheating and consequent

The light bulbs fitted to this heater are standard clear 40W max. E14 candle lamps, butdue to the indeterminate life span and ease of replacement, the

the nation’s favourite forPLUMBING & HEATING SUPPLIESSECURE PAYMENTSshop online with confidenceFREE SHIPPINGon all orders over £100 to mainland UK

4. I Have a problem that is different to those in the previous examples 1- 3.Following is a list of useful telephone numbersFor general advice about y

© Baxi Heating U.K. Limited 2006.All rights reserved. No part of this publication may be reproduced in any material form(including photocopying), stor

Safety First.Baxi Fires Division heaters are CE Approved and designed to meet the appropriateBritish Standards and Safety Marks.Quality and Excellence

HANDLING AND UNPACKINGBefore continuing any further with the installation of this heater please read thefollowing:Unpacking the Dream and Bolero heate

Always! Always install the heater in accordance with this guide. If in doubt obtain expert advice.! Always make sure the electrical socket is access

Where can I fit the heater?This heater can be fitted into fireplaces or surrounds where the following dimensionsare available.Width 400mm - 450 mm (

Removing the cable guide1.Before removing the cable guide please note that the wider part of the cable guide ison the outer edge of the base (See figu

Removing the fasciaDecadent, Eternal, Obsession and Victorian heaters.1. Remove the two fascia securing screws (See figure 2).Remove the front fascia